This dataset contains raw mechanical measurements of standard uniaxial tests in 1) tension; 2) compression; 3) compression with creep deformation (load hold); 4) compression with creep and mechanical oscillations. The data is used by Schaefer et al., 2023, (https://doi.org/10.55575/tektonika2023.1.1.10). Experiments consisted of 1) standard Uniaxial Compressive strength tests; 2) Brazilian tensile strength tests; 3) Creep tests in compression and tension; 4) Creep and mechanical oscillations tests in compression and tension. For experiments in 1 in compression, a rock cylinder of 20x40 mm (diameter x height) is loaded at a constant deformation rate in a uniaxial press, for each test type until 1) failure; 3) a target stress that is then held constant for 5h before moving to a different target stress and repeating the process; and 4) to a target stress that is then held for 30 mins before inducing stress oscillations for 40 minutes. The stress is then held constant at the end of oscillations for another 30 mins. Target stresses corresponded to 50; 60 and 70% of the average compressive strength measured in test type 1. For experiments in 1), 3) and 4) in tension, a rock disc of 40x20 mm (diameter x height) is loaded at a constant deformation rate in a uniaxial press under the same stressing configurations as in compression. More details of the methods can be found in the publication Schaefer et al., 2023. Volcanic domes and edifices are inherently unstable owing to their structure and rapid emplacement/growth, further enhanced by both mechanical and thermal variations due to the movement of magma. Understanding the long-term mechanical response and fatigue of their rock constituents is thus key to understanding their stability. Experimental datasets can help quantify the amount of deformation that rocks can sustain before failure, helping us to understand possible rock failure events at larger scale at volcanoes. All data were collected at the University of Liverpool and analysed at the University of Liverpool, UK, at the USGS, USA and LMU Munich, Germany. All samples were collected at Unzen volcano, Japan. Experiments and data analysis were carried in 2021 and 2022.
